Products | Store | Support | Register | Media | Company  

Knowledge base ds760 Servo

Question #7
I plugged my servo to the gyro with the wrong servo type selected. It is damaged?
Answer
As a general rule 1520uSec/333Hz capable servos will also happily run at 1520uSec/250Hz but not the other way round. In certain cases use of the wrong uSec/Hz setting will cause the servo to travel to the end of its range and bind. If left unnoticed for several seconds the servo will very likely get damaged as a result of the binding and excessive current passing through the stalled motor. If the servo was left binding for more than a brief moment you should thoroughly test it and seek expert advice from the servo manufacturer before using it in flight. No damage is caused to the gyro if the wrong servo mode is used.
Back to Servo
Products | Store | Support | Register | Media | Company
  ©2004-2021 Spartan RC - T&Cs of access.
Home | Contact Us