 |
 |
|
|
|
|
|
• Tail Servo Type - Select the tail servo type you are using. Once the correct servo type is selected you may plug the tail servo to the SV4 port of Vortex.
|
| • Tail Servo Direction - Operate the rudder stick and check if the tail rotor pitch moves the correct way. Reverse this parameter as needed. |
| • Tail Servo Trim - Adjust this value to achieve 90 degrees angle between the tail servo horn and linkage. |
| • Tail Servo CW Endpoint - Adjust the servo travel so it reaches maximum tail rotor pitch without binding. If the helicopter manufacturer provides a recommender travel distance or tail pitch range use that instead. For optimal performance the sum of CW+CCW endpoints should be greater than 200%. If the sum is less, move the servo ball link inwards to reduce the tail's mechanical gain. |
| • Tail Servo CCW Endpoint - As above. |
| • Complete - The tail setup is now complete. Please proceed to the governor setup. |
|
 |
|
