Products | Store | Forum | Support | Register | Media | Company  

Knowledge base Quark Firmware

Topics in Firmware

Topic Question Answer
89 Quark user guide addendum and firmware release notes. User quide doc ver 1.0 addendum Page 11 in table [1 flash]: 5083MG should be changed to 5084MG Page 11 in "Gyro Configuration" section...
29 Can I find the firmware version of my gyro without connecting it to the computer? After the configuration mode is completed the LED will remain switched on for a further 30 seconds. It will then briefly switch off before the...
30 Where can I download the firmware? The firmware that matches your gyro will be automatically downloaded though the firmware loader tool. Connection to the Internet is required during...
76 Does the firmware update actually go to your computer, the Flash-Link, or the gyro? The firmware update is for your gyro. You will need to connect the gyro to your computer and use the firmware update tool which will automatically...
78 Why do I have to register before I can update the firmware? The link between the registration and firmware update systems was put in place for the interest of safety. Although every conceivable test is done...
51 The firmware update failed and my gyro is now dead. Even if the Status light does not light up the gyro continues to function for the purpose of running the firmware update again. Just run the update...

Back to Knowledge base
Products | Store | Forum | Support | Register | Media | Company
  ©2004-2017 Spartan RC - T&Cs of access.
Home | Contact Us